If you are interested in RLC-410W or already have ordered it, check out this article to see what you can get in the box and how to start using it.

Part 1: Unboxing

Part 2: Product Overview

Part 3: Installation 

Part 4: Initial Setup

Unboxing for RLC-410W

410 what s in the box

Product Overview 

You may find detailed information about the structure and components of the camera below. 

410W 4MP

  1. Antenna
  2. Mount
  3. Metal Aluminum Case
  4. 18 IR LEDs
  5. High-Definition Lens (f=4.0mm)
  6. Daylight Sensor

410W 4MP TWO

  1. Micro SD Card Slot

410W 4MP THREE

  1. Power
  2. Reset Button
  3. Network 
  4. Waterproof Lid

Installation

Install the Camera

Please refer to the instructions below to install your camera. 

Step 1. Take out the mounting wrench, and adjust the camera to any angle you want.

Step 2. Tighten this screw toward the direction of the Lock symbol after you adjust the camera to a suitable angle.

Step 3. If you want to adjust the angle of this camera, you can loosen the screw toward the direction of Unlock symbol.

installation 410W

 Note: 

1. Twist it with the wrench to unlock, and adjust the cam (green part) in any direction.

2. After adjustment, twist it back to lock it.

3. Store the wrench here for later use.

For more information, you could refer to the articles below: 

Install the Micro SD card

Please refer to the steps below to install the micro SD card. 

Step 1. Find the micro SD card slot at the back of the camera and unscrew the screws to open it.

SD

Step 2. Insert the micro SD card in the direction of the micro SD card in the picture below, please use your fingernail (or use the provided reset needle) to push the micro SD card in until you feel it is locked, and you will hear a click sound and the micro SD card will not pop out if the camera is inserted in properly.

SD TWO

Step 3. Screw the screws to close the cover tightly.

SD THREE

Initial Setup

For initial setup, please power on this camera with a DC adapter and also connect the camera to your router LAN port with an Ethernet cable, and then follow the steps to set up your camera. Please make sure your camera and your phone are on the same network.

  • On Reolink App

    Step 1. If you've opened the Add Device Automatically option on the Settings page, you can tap this device on the Device List page and turn to step 2 directly. If you don't enable that option, you can tap the Add icon on the upright corner, and scan the QR code on the camera to add this device.
    Step 2. Create the password and name the device.
    create password
    name device
    Step 3. Choose the WiFi network you want to join, enter the password of the WiFi network, and then tap Save to save the configuration.
    wifi settings
    wifi pwd
    For more detailed instructions, you may refer to the articles below:
    How to Initially Set up WiFi cameras via Reolink APP 

  • On Reolink Client

    Step 1. Launch Reolink Client, click on "+" icon on the right top corner, tape the fresh icon beside Scan Device(s) in LAN, then choose the device you want to add.
    UID
    Step 2.  Please enter the camera's username and password, then click Login to log in to the device. The default username is "admin" and the password is blank (no password).RLC 410W
    For more detailed instructions, you may refer to the article: How to Initial Set up WiFi Cameras via Reolink Client (New Client)