How to Install RLC-842A/RLC-542WA/RLC-422/RLC-422W

This article will guide you through the installation of RLC-842A. Please follow the instruction step by step below during the installation.

Applies to: RLC-422, RLC-422W, RLC-542WA, RLC-842A

Here is the video to install RLC-842A:

Here is the video to install RLC-422/RLC-422W:

Step 1. Put the mounting template on the ceiling and drill holes at the indicated locations.

Step 2. Screw the dome cover off with the mounting wrench.

Step 3. Screw the camera to the ceiling.

Step 4. Loosen the two screws on both sides of the camera and adjust the camera viewing angle.

Step 5. Tighten the screws and screw the cover back to the camera.

Done! You've successfully mounted the camera.

Helpful？

Thanks for your feedback! You can click again to cancel and feed back again.

Yes

Sorry about that. We'll be grateful if you can provide some advice.

Thank you for your feedback. Please leave your email address so that we can get in touch with you when necessary.

I've read and understood the Terms & Conditions and Privacy Policy , and I understand that Reolink will use my personal data (email) to facilitate my authentication.

submit

You have clicked too often. Please try again tomorrow.